Skip to content

How to Adjust Mechanical Disc Brakes

Stop the rub and get a firm lever.

By Medell. Editorial2 min read
Bicycle rear wheel with a disc brake
Adrian Rudzki / Unsplash

Before you start

Difficulty
Intermediate
Estimated time
20 min

Tools required

  • •Hex keys (usually 5 mm for caliper bolts)
  • •Torx key if your caliper uses them
  • •Isopropyl alcohol and a clean rag

Safety

  • •Do not touch rotors or pads with oily fingers.
  • •Test brakes at walking speed before riding.

Mechanical disc brakes use a cable to push one pad (usually the outer pad) toward the rotor, which flexes slightly to meet the fixed inner pad. As pads wear, the gap grows and the lever travels further. A few adjustments bring back a firm, quiet brake.

Before you start

  • Check the pads. If the friction material is worn close to the backing plate, replace them first. See how to replace brake pads.
  • Spin the wheel and check that the rotor is straight. A bent rotor will rub however well the caliper is set.
  1. 01

    Set the fixed pad

    Turn the inner pad adjuster (often a hex or knob on the inboard side) until the pad sits close to the rotor without touching it.

  2. 02

    Centre the caliper

    Loosen the two caliper mounting bolts slightly, squeeze the brake lever firmly, and tighten the bolts while holding the lever.

  3. 03

    Adjust cable tension

    Use the barrel adjuster at the lever or caliper to take up slack until the brake engages well before the lever reaches the bar.

  4. 04

    Check for rub

    Spin the wheel. If it rubs, back the inner pad off slightly or re-centre the caliper.

  5. 05

    Test

    Squeeze the lever hard several times, then test at walking speed.

Squealing?

Noise usually means contamination or glazed pads. Clean the rotor with isopropyl alcohol. If the pads are contaminated with oil, replace them.

Frequently asked questions

Can a bent rotor be straightened?

Small bends can often be trued carefully with a rotor truing tool. Heavily bent or very worn rotors should be replaced.

How do I know when a rotor is worn?

Rotors have a minimum thickness, often stamped on the rotor itself. Measure with calipers or ask a shop.

Up next · 2 min readHow to Check and Replace Bike Brake Pads →

The Medell. Letter

New rides, workshop guides and reviews, in your inbox.

Free. Every two weeks, never daily. One-click unsubscribe. See our privacy policy.

Brakes

How to Check and Replace Bike Brake Pads

Worn brake pads are the most common brake problem, and the easiest to fix. How to tell when pads are worn and how to replace them on rim and disc brakes.

Beginner20 min job
Brakes

Hydraulic Disc Brakes: Bleed or New Pads?

Spongy lever, squealing, or fading power? Each symptom points to a different fix. A troubleshooting guide for hydraulic disc brakes.

Intermediate45 min job
Troubleshooting

How to Fix a Squeaky, Clicking or Creaking Bike

Squeaks, clicks and creaks usually point to a handful of causes. A troubleshooting guide to the most common bike noises and how to fix them.

Intermediate30 min job

The Medell. Letter · Free

Free. Every two weeks, never daily. One-click unsubscribe. See our privacy policy.

  1. 01One workshop fixA repair you can do this weekend, with tools and time listed.
  2. 02One road worth ridingRoutes and rides from around the islands.
  3. 03Gear notes, honestly labelledHands-on or research-based, always said up front.