Skip to content

How to Adjust a Front Derailleur

Height, angle, limit screws and cable tension.

By Medell. Editorial2 min read
Close-up of a bicycle derailleur and sprocket
Brina Blum / Unsplash

Before you start

Difficulty
Intermediate
Estimated time
30 min

Tools required

  • •Hex keys
  • •Small Phillips screwdriver
  • •Cable cutters if replacing the cable

Safety

  • •Keep fingers away from the chainrings when turning the cranks.

Front derailleurs need fewer adjustments than rear ones, but the order matters. Work through these steps in sequence.

  1. 01

    Set the height

    The outer cage should clear the largest chainring's teeth by roughly 1–3 mm. Check your manufacturer's figure.

  2. 02

    Set the angle

    The outer cage plate should run parallel to the chainrings when viewed from above.

  3. 03

    Set the low limit

    With the chain on the small ring and largest cog, adjust the L screw so the inner cage just clears the chain.

  4. 04

    Tension the cable

    Pull the cable taut and clamp it. Use the barrel adjuster to fine-tune.

  5. 05

    Set the high limit

    Shift to the big ring and smallest cog. Adjust the H screw so the chain shifts reliably without falling off the outside.

Frequently asked questions

Why does my chain rub the front derailleur in some gears?

Some rub is normal at extreme gear combinations. Many road shifters have a small "trim" position that moves the cage slightly; otherwise, avoid cross-chaining.

Why does my chain drop off the small chainring?

The low limit screw may be too loose, or the cable tension may be off. A chain catcher can also help on some bikes.

Is front derailleur adjustment different on electronic groupsets?

Yes. Electronic systems are adjusted through their own buttons or app. Follow the manufacturer's instructions.

Up next · 2 min readHow to Check Chain Wear and Know When to Replace Your Chain →

The Medell. Letter

New rides, workshop guides and reviews, in your inbox.

Free. Every two weeks, never daily. One-click unsubscribe. See our privacy policy.

Drivetrain

How to Clean and Lube a Bicycle Chain

A clean, correctly lubricated chain shifts better, runs quieter and wears your cassette and chainrings more slowly. Here is the full routine.

Beginner20 min job

The Medell. Letter · Free

Free. Every two weeks, never daily. One-click unsubscribe. See our privacy policy.

  1. 01One workshop fixA repair you can do this weekend, with tools and time listed.
  2. 02One road worth ridingRoutes and rides from around the islands.
  3. 03Gear notes, honestly labelledHands-on or research-based, always said up front.