Rear Derailleur Adjustment: Limit Screws, B-Tension and Indexing
Fix skipping, hesitating and noisy shifts in the right order.
Before you start
- Difficulty
- Intermediate
- Estimated time
- 30 min
- •Repair stand (or a helper to lift the rear wheel)
- •2 mm or 2.5 mm hex key
- •Small Phillips screwdriver
- •Cable cutters (if replacing cable)
- •Never put fingers near the spokes or chain while pedalling the bike in a stand.
- •If the derailleur hanger is bent, have it aligned before adjusting anything else.
Tools required
Safety
Before reaching for the barrel adjuster, confirm the basics: the derailleur hanger is straight, the cable and housing are in good condition and the chain is not worn. Adjustments cannot fix damaged parts.
1. Set the limit screws
The H (high) and L (low) screws stop the derailleur moving past the smallest and largest cogs. Adjust them with the cable slack so you are setting physical limits, not indexing.
2. Set B-tension
The B-screw sets the gap between the upper jockey wheel and the cassette. Follow the gap recommended by your derailleur's manufacturer, measured in the largest cog.
3. Index the shifting
- 01
Tension the cable
Shift to the smallest cog, pull the cable taut and clamp it.
- 02
Shift up one cog
If the chain hesitates, add tension by turning the barrel adjuster anticlockwise a quarter turn at a time.
- 03
Check across the range
Shift through every gear. If it overshoots on the way down, remove tension slightly.
Common shifting problems and likely causes
| Symptom | Likely cause |
|---|---|
| Hesitates shifting to bigger cogs | Cable tension too low |
| Hesitates shifting to smaller cogs | Cable tension too high or dirty housing |
| Skips under hard pedalling | Worn chain or cassette, or poor indexing |
| Chain falls off the largest or smallest cog | Limit screws set too loose |
| Shifting fine in some gears, poor in others | Bent derailleur hanger |
Frequently asked questions
How do I know if my derailleur hanger is bent?
Look at the derailleur from behind the bike. The jockey wheels should line up vertically under the cogs. If the cage tilts toward the wheel, the hanger is likely bent. A shop can straighten it with an alignment tool or replace it.
What does the B-screw actually do?
It sets how close the upper jockey wheel sits to the cassette. Too close and it grinds on the large cogs; too far and shifting becomes slow and vague.
Why did my shifting go out after fitting a new wheel?
Cassettes can sit in slightly different positions on different hubs. Re-index with the barrel adjuster; small changes usually fix it.
The Medell. Letter
New rides, workshop guides and reviews, in your inbox.
Free. Every two weeks, never daily. One-click unsubscribe. See our privacy policy.
Keep reading
How to Check Chain Wear and Know When to Replace Your Chain
A stretched chain wears your cassette and chainrings fast. How to measure chain wear with a checker or a ruler, and when to replace it.
How to Clean and Lube a Bicycle Chain
A clean, correctly lubricated chain shifts better, runs quieter and wears your cassette and chainrings more slowly. Here is the full routine.
How to Adjust a Front Derailleur
Chain dropping or not reaching the big ring? A step-by-step guide to setting front derailleur height, angle, limits and cable tension.