How to Install and Remove Bike Pedals
Why the left pedal is reverse-threaded.
Before you start
- Difficulty
- Beginner
- Estimated time
- 10 min
- •15 mm pedal wrench or the correct hex key (often 6 or 8 mm)
- •Grease
- •Cross-threading damages crank arms; start threads by hand.
Tools required
Safety
Pedals are marked R and L. The right (drive-side) pedal has a normal thread; the left pedal has a reverse thread so it does not loosen while you ride.
| Pedal | To tighten | To loosen |
|---|---|---|
| Right (drive side) | Clockwise | Anti-clockwise |
| Left | Anti-clockwise | Clockwise |
- 01
Grease the threads
A thin layer of grease prevents creaks and seizing.
- 02
Start by hand
Thread each pedal in by hand for several turns to avoid cross-threading.
- 03
Tighten firmly
Finish with the wrench. Check your pedal maker's torque value if you have a torque wrench.
Removing a stuck pedal
- Use a long pedal wrench for leverage, and double-check you are turning in the loosening direction.
- Position the wrench and crank so you push down, using body weight, while holding the opposite crank or brake.
- A little penetrating oil left for a while can help.
- If it still will not move, a bike shop can remove it without damaging the crank.
Frequently asked questions
Should I use threadlocker on pedals?
No. Use grease. Pedals are designed to stay tight through the reverse-threaded left side and the natural action of pedalling.
Do I need pedal washers?
Some carbon or alloy cranks and pedal makers recommend thin washers. Follow the crank and pedal manufacturers' guidance.
How tight should pedals be?
Firmly tight, ideally to the torque value given by your pedal maker. Overtightening makes them hard to remove later.
The Medell. Letter
New rides, workshop guides and reviews, in your inbox.
Free. Every two weeks, never daily. One-click unsubscribe. See our privacy policy.
Keep reading
How to Set Your Saddle Height
Saddle height affects comfort, power and knee health. Simple methods to find a good starting height and fine-tune it.
How to Set Up a Bike Computer and Sensors
Mount your bike computer, pair speed, cadence and heart-rate sensors over ANT+ or Bluetooth, and set wheel size for accurate data.
How to Replace Bike Gear Cables and Housing
Sluggish shifting is often just old cables. How to replace inner cables and housing, cut housing cleanly and set tension afterwards.