Skip to content

How to Set Your Saddle Height

The single most important fit adjustment.

By Medell. Editorial2 min read
Cyclist riding a gravel bike on a sunny road
Markus Spiske / Unsplash

Before you start

Difficulty
Beginner
Estimated time
15 min

Tools required

  • •Hex keys
  • •Tape measure
  • •Marker or tape to note your position

Safety

  • •Never raise the seatpost above its minimum-insertion mark.

A saddle that is too low strains the knees and wastes power; one that is too high makes your hips rock and can cause pain behind the knee.

The heel method (a starting point)

  1. 01

    Sit on the bike

    Lean against a wall or use a trainer so you can sit naturally.

  2. 02

    Put your heel on the pedal

    Pedal backwards to the bottom of the stroke with your heel on the pedal.

  3. 03

    Adjust the height

    Your leg should be straight with your heel on the pedal. When you ride with the ball of your foot, this leaves a slight bend at the knee.

Fine-tuning

  • Make changes of 2–5 mm at a time and ride a few times before changing again.
  • Your hips should stay level on the saddle at the bottom of the stroke.
  • Check saddle tilt: start level and adjust only slightly.

Setback and tilt

Saddle setback, how far forward or back it sits on the rails, affects how your weight is balanced between your hands and seat. Start with the saddle centred on its rails. Keep the saddle roughly level; a small nose-down tilt can relieve pressure, but too much makes you slide forward and load your hands.

Frequently asked questions

Why does the front of my knee hurt?

Pain at the front of the knee is often linked to a saddle that is too low or too far forward. Pain behind the knee is often linked to a saddle that is too high. If pain persists, see a bike fitter or physiotherapist.

How do I transfer my saddle height to a new bike?

Measure from the centre of the bottom bracket to the top of the saddle along the seat tube line, and set the new bike to the same distance.

Should I change saddle height for new shoes or pedals?

Yes, check it. Different sole and pedal stack heights change your effective leg extension.

Up next · 2 min readHow to Wrap Handlebar Tape →

The Medell. Letter

New rides, workshop guides and reviews, in your inbox.

Free. Every two weeks, never daily. One-click unsubscribe. See our privacy policy.

Component Installation

How to Wrap Handlebar Tape

Fresh bar tape makes an old bike feel new. How to remove old tape and wrap new tape evenly, with a clean finish at the hoods and tops.

Beginner30 min job
Component Installation

How to Install and Remove Bike Pedals

Pedals are easy to fit, as long as you know the left pedal has a reverse thread. How to remove and install pedals without damaging the cranks.

Beginner10 min job
Component Installation

How to Set Up a Bike Computer and Sensors

Mount your bike computer, pair speed, cadence and heart-rate sensors over ANT+ or Bluetooth, and set wheel size for accurate data.

Beginner20 min job

The Medell. Letter · Free

Free. Every two weeks, never daily. One-click unsubscribe. See our privacy policy.

  1. 01One workshop fixA repair you can do this weekend, with tools and time listed.
  2. 02One road worth ridingRoutes and rides from around the islands.
  3. 03Gear notes, honestly labelledHands-on or research-based, always said up front.