Skip to content

How to Replace Bike Gear Cables and Housing

Bring back crisp shifting.

By Medell. Editorial2 min read
Man working on a bicycle in a garage
Anton Savinov / Unsplash

Before you start

Difficulty
Intermediate
Estimated time
45 min

Tools required

  • •Cable and housing cutters
  • •Hex keys
  • •New shift cable and housing
  • •Ferrules and cable end caps
  • •Awl or pick to open the housing liner

Safety

  • •Cut cable ends can be sharp; crimp an end cap on straight away.

Shift cables stretch slightly and collect dirt inside the housing over time. Replacing them is one of the most effective ways to restore light, accurate shifting.

Use the right parts

  • Use shift housing for gears and brake housing for brakes; they are built differently.
  • Road and mountain shifters use the same cable diameter in most cases, but check the head shape fits your shifter.
  • Replace the housing as well as the cable for the best result.
  1. 01

    Shift to the smallest cog

    This releases tension and exposes the cable head in most shifters.

  2. 02

    Remove the old cable

    Cut off the end cap, loosen the derailleur clamp bolt and pull the cable out through the shifter.

  3. 03

    Cut the new housing

    Use the old pieces as length guides. Cut cleanly with proper cutters, then open the plastic liner with an awl so the cable runs freely.

  4. 04

    Fit ferrules

    Put ferrules on both ends of each housing section.

  5. 05

    Thread the cable

    Feed the new cable through the shifter, housing and frame guides to the derailleur.

  6. 06

    Tension and clamp

    Pull the cable taut by hand and tighten the clamp bolt. Trim and crimp an end cap.

  7. 07

    Index the gears

    Fine-tune with the barrel adjuster. See rear derailleur adjustment.

Frequently asked questions

How often should gear cables be replaced?

Replace them when shifting becomes sluggish and adjustment does not help, or when cables are frayed or rusty. Bikes ridden often in rain need it sooner.

Are expensive coated cables worth it?

They can make shifting smoother and resist corrosion, but clean, well-routed standard cables and good housing work well too.

Can I replace only the inner cable?

Yes, if the housing is clean and undamaged. Replacing housing at the same time gives the biggest improvement.

Up next · 2 min readHow to Install and Remove Bike Pedals →

The Medell. Letter

New rides, workshop guides and reviews, in your inbox.

Free. Every two weeks, never daily. One-click unsubscribe. See our privacy policy.

Component Installation

How to Install and Remove Bike Pedals

Pedals are easy to fit, as long as you know the left pedal has a reverse thread. How to remove and install pedals without damaging the cranks.

Beginner10 min job
Drivetrain

How to Clean and Lube a Bicycle Chain

A clean, correctly lubricated chain shifts better, runs quieter and wears your cassette and chainrings more slowly. Here is the full routine.

Beginner20 min job

The Medell. Letter · Free

Free. Every two weeks, never daily. One-click unsubscribe. See our privacy policy.

  1. 01One workshop fixA repair you can do this weekend, with tools and time listed.
  2. 02One road worth ridingRoutes and rides from around the islands.
  3. 03Gear notes, honestly labelledHands-on or research-based, always said up front.