Skip to content

How to Replace a Bike Chain

Sizing, breaking and joining a new chain.

By Medell. Editorial2 min read
Close-up of a bicycle chain running over the gears
streetsh / Unsplash

Before you start

Difficulty
Intermediate
Estimated time
25 min

Tools required

  • •Chain tool
  • •Quick-link pliers (optional)
  • •New chain matched to your drivetrain speed
  • •Quick link or connecting pin
  • •Rag and chain lube

Safety

  • •Wear gloves; new chains are coated in grease.
  • •Keep fingers away from the chainrings while pedalling the bike in a stand.

Chains are wear parts. Replacing one on time is far cheaper than replacing a cassette and chainrings worn down by an old chain. If you are not sure whether yours is worn, start with how to check chain wear.

Buy the right chain

Chains are specific to the number of rear speeds: an 11-speed drivetrain needs an 11-speed chain. Some brands also specify a particular chain or quick link for their groupsets, so check the manufacturer's compatibility notes.

Size the new chain

  • Match the old chain if it was the correct length: lay both side by side and count links, not length, because the old chain has worn longer.
  • Or use the big-big method: wrap the chain around the largest chainring and largest cog, bypassing the rear derailleur, then add the length your derailleur manufacturer recommends (often one inch, or two links).
  • Full-suspension mountain bikes need the suspension compressed when sizing; follow the frame maker's guidance.

Remove the old chain

  1. 01

    Shift to the smallest cog

    This gives the most slack and makes removal easier.

  2. 02

    Open the quick link or push out a pin

    Use quick-link pliers to open an existing quick link, or push a pin out with a chain tool.

  3. 03

    Pull the chain off

    Feed it out through the derailleurs and note how it was routed through the rear derailleur cage.

Install the new chain

  1. 01

    Route the chain

    Feed it over the smallest cog, through the rear derailleur jockey wheels and inside the front derailleur cage. Directional chains have markings that must face outward.

  2. 02

    Shorten to length

    Use the chain tool to remove excess links, leaving the correct ends for your quick link or pin.

  3. 03

    Join the chain

    Fit the quick link and snap it closed by pedalling with the rear brake held, or press in the connecting pin with the chain tool.

  4. 04

    Check for stiff links

    Backpedal slowly and watch for a link that does not bend freely.

  5. 05

    Test the shifting

    Shift through every gear. A new chain on a worn cassette may skip; if so, the cassette needs replacing too.

Up next · 2 min readHow to Check Chain Wear and Know When to Replace Your Chain →

The Medell. Letter

New rides, workshop guides and reviews, in your inbox.

Free. Every two weeks, never daily. One-click unsubscribe. See our privacy policy.

Drivetrain

How to Clean and Lube a Bicycle Chain

A clean, correctly lubricated chain shifts better, runs quieter and wears your cassette and chainrings more slowly. Here is the full routine.

Beginner20 min job

The Medell. Letter · Free

Free. Every two weeks, never daily. One-click unsubscribe. See our privacy policy.

  1. 01One workshop fixA repair you can do this weekend, with tools and time listed.
  2. 02One road worth ridingRoutes and rides from around the islands.
  3. 03Gear notes, honestly labelledHands-on or research-based, always said up front.