Skip to content

How to Set Up Tubeless Tires

Tape, valves, sealant and seating the bead.

By Medell. Editorial2 min read
Close-up of a bicycle tire
Alessandra Caretto / Unsplash

Before you start

Difficulty
Intermediate
Estimated time
45 min

Tools required

  • •Tubeless rim tape of the correct width
  • •Tubeless valves
  • •Sealant
  • •Valve core tool
  • •Tire levers
  • •Floor pump or tubeless booster
  • •Soapy water

Safety

  • •Wear eye protection when seating beads at high pressure.
  • •Never exceed the maximum pressure of your rim or tire.

Only tubeless-ready (or tubeless-compatible) rims and tires should be set up tubeless. Check both before you start. For the pros and cons, see our piece on whether tubeless is worth it.

  1. 01

    Clean and tape the rim

    Remove old tape, clean the rim bed and apply tubeless tape under tension, overlapping at the valve hole.

  2. 02

    Install the valve

    Pierce the tape at the valve hole and fit the tubeless valve, tightening the lock ring by hand.

  3. 03

    Mount one side of the tire

    Fit one bead fully onto the rim.

  4. 04

    Add sealant

    Pour sealant into the tire before fitting the second bead, or later through the valve with the core removed. Follow the sealant maker's recommended amount for your tire size.

  5. 05

    Seat the bead

    Fit the second bead, brush soapy water on both beads and inflate quickly. You will hear pops as the beads seat.

  6. 06

    Spread the sealant

    Spin and tilt the wheel so sealant coats the inside of the tire. Leave it on its side for a while, then flip it.

If the bead will not seat

  • Remove the valve core for higher airflow.
  • Use a tubeless booster or a pump with a charge chamber.
  • Push the beads into the rim's centre channel opposite the valve.

Frequently asked questions

How much sealant should I use?

Follow the sealant maker's chart for your tire size. Wider tires need more sealant than narrow road tires.

How often should I top up sealant?

Every few months is typical, and more often in hot weather because sealant dries faster. Shake the wheel and listen, or check through the valve.

Can I put a tube in a tubeless tire?

Yes. If a puncture will not seal, remove the valve, wipe out excess sealant, and fit a tube as you would with a normal tire. Check for anything sharp left in the tire first.

Up next · 2 min readFixing a Flat at the Roadside →

The Medell. Letter

New rides, workshop guides and reviews, in your inbox.

Free. Every two weeks, never daily. One-click unsubscribe. See our privacy policy.

Wheels & Tires

Fixing a Flat at the Roadside

Every rider should be able to replace an inner tube in under fifteen minutes. Here is the method, plus the small checks that prevent repeat flats.

Beginner15 min job
Wheels & Tires

How to True a Bike Wheel

A wobbly wheel rubs the brakes and rides badly. How spoke tension moves the rim, and how to fix a small side-to-side wobble at home.

Advanced40 min job

The Medell. Letter · Free

Free. Every two weeks, never daily. One-click unsubscribe. See our privacy policy.

  1. 01One workshop fixA repair you can do this weekend, with tools and time listed.
  2. 02One road worth ridingRoutes and rides from around the islands.
  3. 03Gear notes, honestly labelledHands-on or research-based, always said up front.